I Preparation before starting up ,II How to start the MEPER blow molding machine, III How to turn off the MEPER blow molding machine ,IV Regular maintenance for MEPER blow molding machine
READ MORE1. Start-up precautions1. Check the hydraulic oil level gauge of the blow molding machine and each hydraulic device to keep the oil level of each oil tank above the reference oil level.2. The materials used in the extrusion blow molding machine should meet the required drying requirements, and furth
READ MOREClean and scrub the oil stains on various parts of the blow molding machine and the dust in the electric control box;Disassemble the gearbox and bearing gland, check the quality of the lubricating oil and the amount of metal powder in the oil, and clean and change the oil if necessary;Check the wear......
READ MORENowadays, there are many manufacturers of hollow blow molding machines, which are all kinds and mixed. How to choose a suitable hollow blow molding machine without spending money is very important. There are actually many pitfalls in the promotion of hollow blow molding machines. Some people buy hol
READ MOREThe hollow blow molding machine must be strictly prepared for driving before driving. The main contents are the following eight points:The first point: the cooling water of the cooling material must be turned on, and the phenomenon of screw bite is even caused.The second point: preheat hydraulic oil......
READ MOREGood hollow blow molding products need high-quality hollow blow molding machines to produce, so the requirements for each part of the machine are very high. When installing the reciprocating cylinder, the following points should be done:1. Before installing the cylinder of the hollow blow molding ma
READ MORE