Call Us Today/WhatsAPP

(+86)-138-128-59969
News
You are here: Home » News
factory show.jpg
Installation sequence of MEPER plastic blow molding machine

Watering stick cement, leaving holes in the foundation. The concrete should be covered with grass bags and watered twice a day after 24h for health preservation. The ambient temperature should not be lower than 5 degrees.

READ MORE
2023 01-11
2.jpg
Why is the screw of the plastic blow molding machine abnormal?

Why is the screw of the plastic blow molding machine abnormal? In the process of using the plastic blow molding machine, everyone has more or less encountered the situation that the screw of the plastic blow molding machine cannot discharge normally. Meper Machinery will discuss with you today......

READ MORE
2022 12-19
MEPER extrusion blow molding machine.jpg
Reasons for the maintenance of large plastic blowing machine

Reasons for the maintenance of large plastic blowing machineAs we all know, the plastic blowing machine needs maintenance for maintenance, especially the large plastic blowing machine, but I do not know why the blowing machine is required for maintenance. Therefore, Meper machine......

READ MORE
2022 12-05
MEPER blow molding machine.jpg
Quality requirements for blow molding products

The quality requirements of blow molding products are also very strict. Today, our blow molding machine factory will introduce them to you through the following points. I hope you can understand the quality requirements of blow molding products more clearly. 1. Appearance quality requirements (1) Th

READ MORE
2022 11-24
MEPER blow molding machine.jpg
How to do if there is a problem for blow molding machine?

In the production process of blow molding machine, there are always various problems, such as the deficiency of the blown mold. How should we solve some deficiencies?

READ MORE
2022 11-16
MEPER blow molding machine.jpg
Blow molding machine common problems repair method

It is very common to encounter some production faults in the production process of plastic products. Today, MEPER MACHINERY has made a collection to summarize some common fault problems. How should we solve them?1. The feeding plate is stuck. The problem of stuck material in the feeding process may

READ MORE
2022 11-15