Technical requirements for wall thickness control of MEPER blow molding machinesMany people may know that the molding technology of MEPERextrusion blow molding machine is to make the plasticized billet close to the inner wall of the mold by air pressure. The production mode of mold billet is extrusi
READ MOREApplication of multi-layer blow molding _ Meper Machine(1) Food and beverages. Although the glass bottle is a permanent impermeable container, it is not limited by the August 4th disinfectant and sterile disinfectant. However, co-extruded blow-molded multi-layer bottles are not easy to break, can be
READ MOREAbout frequency converter of blow molding machineMany people know that inverter can save electricity, but do not know why inverter can save electricity, and how much at the same time, is the high frequency or low frequency save more? In the following content, we have sorted out some of the customers
READ MOREHandling of overload trip fault of inverter of blow molding machineThe overload trip of the converter is one of the common problems in the operation of blow molding machine.The overload trip of frequency converter should be dealt with by scientific and effective method.This article will introduce th
READ MOREWatering stick cement, leaving holes in the foundation. The concrete should be covered with grass bags and watered twice a day after 24h for health preservation. The ambient temperature should not be lower than 5 degrees.
READ MOREIs there any noise in the blowing molding machine? How to solve it?The operation process of the blowing machine is to preheat and heat up, set the temperature value on the temperature control meter according to the process requirements, start the heating system for heat up......
READ MORE