Auxiliary equipment required to run a blow molding machine

The auxiliary equipment required to run the blow molding machine mainly includes: air tank, air compressor, cold water tower, refrigerator, mixer, hydraulic guillotine, crusher, and shredder.

During the normal operation of the blow molding machine, the blowing system is required, and the air tank and the air compressor provide gas during the normal operation of the blow molding machine. The air compressor is connected with the air tank, and the air tank is connected with the air cabinet of the blow molding machine through a pipeline to provide pressure gas for different devices of the blow molding machine.

When the blow molding machine is running normally, the temperature of many parts will increase with the operation of the machine. At this time, cooling water is needed to cool down, such as the reducer, the bottom plate of the injection cylinder, the mold, etc. The auxiliary equipment that needs to be used is a cold water tower or a refrigerator. If the overall temperature of the area where the machine is located is not high all year round, below 30 degrees, a cold water tower can be used. If the temperature in the area where the machine is located is above 30 degrees most of the time, a chiller with a higher cooling effect is required.

When using a blow molding machine to produce products, if you produce products of different colors, you need to add color masterbatch to the raw materials. In order to make the color masterbatch and the raw materials mix more uniformly, it is recommended to configure a mixer. If the ambient humidity is relatively high, the mixer Preferably with a drying and dehumidifying function. When customers choose MEPER blow molding machine, we will provide the most suitable mixing equipment for customers to choose according to your local situation.

MEPER blow molding machine

The products produced by the blow molding machine will have flash, and the reuse of flash can effectively reduce the production cost. The equipment that needs to be used to deal with flash or other wastes includes hydraulic guillotine and crusher or shredder. The hydraulic guillotine can cut large pieces of flash or waste into small pieces, and then put them into the crusher to obtain recyclable materials that can be reused. The shredder can directly shred large pieces or unqualified products in debugging into small pieces, and then use the shredder to process them into suitable sizes.

When purchasing a MEPER blow molding machine, we will understand the actual situation of the customer, and recommend the most suitable auxiliary machine according to the customer's needs, so that the customer can purchase the blow molding machine more cost-effectively.